dbx DI1 Active Direct Box

dbx DI1 Active Direct Box – Plug your high-impedance gear into low-impedance equipment with the dbx DI1 Active Direct Box. Using a 9V battery or phantom power from your mixing board or interface, the DI1 takes the high-impedance signal which comes from instruments and other unbalanced TS or XLR sources and transforms it into a low-impedance balanced XLR signal. Low-impedance balanced signals can drive long cables without picking up interference or losing high-end articulation.

The dbx Di1 is a compact high-quality active direct injection box. Ideal for both studios and on the road, the Di1 will ensure audio signals reach their intended destination in both a balanced format and free from unwanted noise.

Connect the output from electric guitars, bass amplifiers, keyboards, etc., directly to a console mixer without the use of a microphone.

Built for toughness and reliability, the Di1 has all the features of a fully featured gig-ready workhorse DI unit.

Features:

• Level and impedance matching function
• Output impedance: > 600 Ohms
• Signal pass through connector
• Output connector: XLR balanced
• Battery LED indicator
• Distortion: (THD) < 0.005% at 1kHz, 0 dBu
• Phantom power LED indicator
• Max Input: + 12 dBu (at 0 dB) Level + 32 dBu (at -20 dB) + 52 dBu (at – 40 dB)
• Output Noise: < -100 dB unweighted
• TS and XLR inputs and outputs
• Frequency response: 10 Hz to 70 kHz, + 0 dB / – 3 dB
• Attenuation control
• Phantom Power: + 18 volts DC to + 48 volts DC
• Ground lift switch
• Main/Standby: 9 V battery
• Input Impedance: > 250 k Ohm
• Metal Chassis

Specifications:

• Input Impedance: > 250 k Ohm
• Max Input: + 12 dBu (at 0 dB) Level + 32 dBu (at – 20dB) + 52 dBu (at – 40 dB)
• Connectors: Two Parallel 1/4″ jack connectors and aparallel XLR connector (unbalanced), 1/4″ Jack: Tip Hot, Sleeve Ground; XLR
• Jack: Pin 2 Hot, Pins 1 and 3 Ground
• Output Impedance: > 600 Ohms
• Output Connectors: XLR balanced
• Distortion: (THD) < 0.005 % at 1 kHz, 0 dBu
• Output Noise: < – 100 dB unweighted
• Frequency Response: 10 Hz to 70 kHz, + 0 dB / – 3 dB
• Main/Standby: 9 Volt battery
• Phantom Power: + 18 Volts DC to + 48 Volts DC

dbx